Regeneration and replacement of softening resin

  1. First, turn off the water source and pull out the PE pipe at the inlet and outlet of the softener;
  2. Unscrew the black two on the softener and pour the softening resin into a clean basin.
  3. Pour 0.5 kg of industrial salt into the basin, add an appropriate amount of tap water (the resin can be submerged);
  4. Place the soaked softening resin in a cool and dry place for 8 hours (preferably at night, just in the morning)
  5. Will soak the resin with tap water and repeatedly rinse until the waste water is without turbidity, no a little salty.
  6. Clean the inside and black two of the softener with clean water. Through the center tube, then loaded with softening resin,
  7. Tighten the black pass and connect the PE pipe for the inlet and outlet water (not connected to the water inlet of the machine temporarily)
  8. Open the tap water inlet switch and discharge the wastewater from the outlet of the softener (secondary flushing).
  9. When the water quantity at the outlet is stable and the water is clear, it can be connected to the inlet of the machine

 

inlet